盾构上穿既有隧道影响及加固分析
DOI:
作者:
作者单位:

1.中铁十九局集团轨道交通工程有限公司 北京;2.taptap点点官方注册铁路环境振动与噪声教育部工程研究中心 江西 南昌

作者简介:

通讯作者:

中图分类号:

U455

基金项目:

国家自然科学(52078213);江西省青年科学基金重点项目(20192ACBL21003);江西省主要学科学术和技术带头人资助计划(20194BCJ22009)


Influence and Reinforcement Analysis of shield passing through existing tunnel
Author:
Affiliation:

Fund Project:

The National Natural Science Foundation of China(52078213);Key projects of Jiangxi Youth Science Foundation(20192ACBL21003);Funding program for academic and technical leaders of major disciplines in Jiangxi Province(20194BCJ22009)

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    以某城市地铁某停车场出入线盾构隧道上穿下部既有盾构隧道工程为研究背景,结合小曲线半径盾构隧道、新建隧道上穿既有隧道等多种特殊工况,采用数值仿真软件模拟了施工中下部既有盾构隧道管片竖向位移情况,对既有隧道注浆加固后的隧道变形值进行分析,并最终提出加固建议。分析结果表明:新建隧道左线及右线的开挖对既有隧道产生的影响有较大差异,同时上部隧道的穿越角度影响既有隧道的沉降位移值,施工隧道线路正下方的既有隧道管片产生的竖向位移比斜下方的隧道管片大5.3mm。提出既有隧道加固方案并对其效果进行模拟分析,模拟结果显示加固后的隧道最大变形减小3.2mm,为4.5mm,小于规范控制安全标准5mm。在此基础上提出了钢支撑环与拱顶注浆相结合的隧道加固方案,并在施工现场进行实施。

    Abstract:

    Based on the research background of the shield tunnel in a parking lot of an urban subway, combined with a variety of special working conditions such as small curve radius shield tunnel and new tunnel crossing the existing tunnel, the vertical displacement of the existing shield tunnel in the middle and lower part of the construction is simulated by numerical simulation, and the tunnel deformation value after grouting reinforcement of the existing tunnel is analyzed, Finally, the reinforcement suggestions are put forward. The analysis results show that the excavation of the left line and the right line of the new tunnel has a great difference in the impact on the existing tunnel. At the same time, the crossing angle of the upper tunnel affects the settlement displacement of the existing tunnel. The vertical displacement of the existing tunnel segment directly below the construction tunnel line is 5.3mm larger than that of the tunnel segment diagonally below. The simulation results show that the maximum deformation of the strengthened tunnel decreases from 3.2mm to 4.5mm, which is less than 5mm of the standard control safety standard. On this basis, a tunnel reinforcement scheme combining steel support ring and arch crown grouting is proposed, and the on-site construction is guided.

    参考文献
    相似文献
    引证文献
引用本文
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:2021-10-13
  • 最后修改日期:2021-11-13
  • 录用日期:2021-11-16
  • 在线发布日期:
  • 出版日期:
Baidu
map
关闭